The particulate filter is a critical component in the exhaust system of modern vehicles.
Its main function is to trap and remove exhaust pollutants, including soot particles and other fuel residues.
However, problems can sometimes arise with the particulate filter, and one of the factors that can contribute to these failures is the failure of the vehicle's turbocharger.
Let's look at why the turbo can cause the particulate filter to fail and vice versa.
Like particulate filters, quality turbochargers are not prone to failure, but they need the right conditions to function properly.
One of the most common reasons for turbo failure is turbocharger failure. presence of contaminants in the lubricant.
Because turbochargers run at high revolutions per minute and withstand high temperatures, the turbo bearings are subjected to high stresses.
If the oil supply to the turbo fails, its bearings can wear prematurely and fail before the engine bearings.
The damage to a turbocharger without oil for five seconds is as damaging as that of an engine without oil for five minutes.
It is important to ensure that the engine oil pressure meets the manufacturer's specifications, but even more important is to check that the lines supplying clean oil at the proper pressure to the turbocharger are free of blockages and contaminants.
If the oil reaching the turbocharger is contaminated or dirty, or if the oil pressure or flow rate is incorrect, turbocharger bearings can be scratched and damaged, leading to rapid wear and ultimately breakage.
For preventing lubricant contamination and avoiding turbo failures the following points are recommended:
(a) New oil and new oil filters, as recommended by the engine manufacturer, must be used during the installation of a new or repaired turbocharger.
(b) Ensure that the oil used is of the correct grade for the engine.
(c) Clean or replace the oil inlet lines to the turbocharger to remove any build-up of carbon or sludge that may restrict oil flow to the turbo bearings.
(d) Clean the oil sump and oil aspirator whenever a turbo repair or replacement is carried out.
If there is a problem with the turbocharger, such as a faulty seal or a clogged oil line, oil may escape and be drawn through the air flow into the particulate filter.
If oil gets into the particulate filter, it can build up and clog the filter, which can reduce its efficiency and cause long-term problems.
If the turbocharger fails, there can be a number of problems, including a loss of engine power and a decrease in fuel efficiency.
One of the lesser known side effects of a failed turbo is the possible failure of the particulate filter.
The particulate filter is periodically cleaned by a regeneration process, which burns the particles trapped in the filter and converts them into ash.
This process is automatically activated when the vehicle detects that the filter is clogged, and works by increasing the exhaust temperature.
However, if the turbocharger is failing, it may not be supplying enough air to the engine, which can cause it to the exhaust temperature does not reach the required level to activate the particulate filter regeneration process.
This means that particles do not burn and accumulate in the filter, which can cause clogging and filter failure in the long term.
In addition, turbo failure can also affect the airflow through the exhaust system in general.
If the turbo is not providing sufficient air to the engine, there may be a build-up of pressure in the exhaust system, which may increase the risk of particulate filter failure.
A clogged particulate filter can cause turbo damage of a vehicle if no action is taken to remedy the problem.
If the filter becomes clogged, the flow of exhaust gases is reduced and this can lead to increase the pressure in the exhaust system and turbocharger.
The increase in pressure can cause the turbocharger to work more The hardest part of the tyre can cause premature wear or even breakage of the tyre.
In addition, excess pressure can lead to leaking turbocharger sealsThis may affect its performance and lead to a loss of engine power.
Therefore, it is important to keep the particulate filter in good condition and to maintain it according to the manufacturer's recommendations in order to avoid damage to the turbo and other engine components.
The particulate filter is a vital component of a vehicle's exhaust system, and its correct functioning is essential to keep pollution levels low.
If the vehicle's turbocharger fails, there can be a number of side effects, including possible failure of the particulate filter.
It is important to take into account this possible connection between turbo failure and particulate filter failuresand take measures to prevent and solve these problems in time.
Drivers should be alert to any changes in engine performance or exhaust system, and should take their vehicle to a reputable mechanic as soon as possible if they notice any problems.
Specialists in the design and manufacture of DPF cleaning machines and catalytic converter cleaning machines.
DPF REVIVAL: Particulate filter cleaning solutions
Copyright © 2023 Iberisa Asesoramiento Gestión y Servicios S.L.
Who are we?
EN 
ES_ES 
CL 
MX 
FR 
DE 
PT 
IT